MOTION-TR ACKI N G LED Security Spotlight User Manualwww.jascoproducts.com1-800-654-8483
102. Route the black and white wires coming from the back of the mounting base through the basket [See Fig. 2]. Align the two mounting screw holes on
113. Locate black and white wires coming from LED light fixture. Strip wires 3/8” (9.5mm) if not previously stripped. Hold BLACK house wire and BLACK fi
12Note: If a wet location junction box was not used, caulk edge of mounting base with silicone weather resistant sealant (not included).5. Locate Hori
137. Connect wire coming from mounting base to wire coming from extension tube. Insert extension tube into mounting base, taking care to not pinch ex-
14Front Motion SensorPerimeter Motion SensorPOWER UPWhen the power is turned on to the fixture, the front lights will turn on and the light housing w
15Minimum Detection DistanceAverage Detection DistanceMaximum Detection DistanceMOTION DETECTION RANGE SET-UPEach adjustable motion sensor can dete
16Upper SensorUpper SensorLower SensorLower SensorCombinedSensorsCombinedSensors150°100°100°Center detection zoneLeft detection zoneRight detectio
1715°TEST MODETEST MODE 1Once the fixture is mounted and positioned, you can test the detection range for each adjustable sensor by placing the fixture
18must be in front of the fixture witin a 15º angle and within 15 ft.) When the fixture receives the command, the lights will turn on and the light hous
19AUTO (Security/Motion tracking) MODEThe light fixture can be placed into AUTO mode at any time (except during initial power up). When the fixture is s
2TABLE OF CONTENTSParts List 3Questions? Missing Parts? 4Installation (Wall mount) 6-9Installation (Eave mount)
20PERIMETER MOTION TRACKING DETECTION (Underneath Fixture)The Light fixture has a separate motion detection sensor and down-firing LEDs located on the b
21FCC StatementThis device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause
22FIVE YEAR LIMITED WARRANTYJasco Products Company warrants this product to be free from manufacturing defects for a period of five years from the orig
is a trademark of General Electric Company and is used under license to Jasco Products Company LLC, 10 E. Memorial Road, Oklahoma City, OK 73114 www
3Thank you for purchasing the GE Motion-Tracking LED Security Spotlight Activation control. This economical, energy efficient outdoor LED light has be
4Questions? Problems? Missing Parts? If you have any questions regarding the installation or operation of the product, Before returning to Retailer, p
5INSTALLATIONSelect an existing outdoor light fixture, either wall or eave mount for replace-ment. The fixture must be connected to 120v, 60hz power sou
6VERTICAL (WALL) MOUNT AND WIRE CONNECTION1. Remove the existing light fixture and disconnect house wires (black, white and ground)[See Fig. 1].WARNIN
72. Route black and white wires coming from back of mounting base through the bottom hole of the gasket [See Fig. 2]. Align the two mounting screw hol
84. If mounting to a wall (in vertical position) ensure the mounting base is correctly oriented with the collar screw positioned downward [See Figur
9Fig. 5A Fig. 5B
Kommentare zu diesen Handbüchern